To install memory and font DIMMs

To install memory and font DIMMs

1. Turn the printer off, and then disconnect all power and interface cables.

HP 3000 3600 3800 as pp03 To install memory and font DIMMs

2. On the right side of the printer, gently pull the black tabs together, and then pull the formatter assembly from the printer.

HP 3000 3600 3800 as mm02 To install memory and font DIMMs

3. Place the formatter board on a clean, flat, grounded surface.

To replace a DIMM that is currently installed, spread the latches apart on each side of the DIMM slot, lift the DIMM up at an angle, and pull it out.

HP 3000 3600 3800 as mm07 To install memory and font DIMMs

4. Remove the new DIMM from the antistatic package, and then locate the alignment notch on the bottom edge of the DIMM.

HP 3000 3600 3800 as mm08 To install memory and font DIMMs

5. Holding the DIMM by the edges, align the notch on the DIMM with the bar in the DIMM slot at an angle and firmly press the DIMM into the slot until it is fully seated. When installed correctly, the metal contacts are not visible.

HP 3000 3600 3800 as mm04 To install memory and font DIMMs

6. Push down on the DIMM until both latches engage the DIMM.

HP 3000 3600 3800 as mm05 To install memory and font DIMMs

HP 3000 3600 3800 note To install memory and font DIMMs NOTE

If you have difficulty inserting the DIMM, make sure that the notch on the bottom of the DIMM is aligned with the bar in the slot. If the DIMM still does not go in, make sure that you are using the correct DIMM type.

7. Align the edge of the formatter board in the tracks at the top and bottom of the slot, and then slide the board back into the printer. Push the formatter firmly until you hear the formatter latches click into place.

HP 3000 3600 3800 as mm06 To install memory and font DIMMs

8. Reconnect the power cable and USB or network cable, and then turn on the printer.
9. After installing a memory DIMM, see Enabling memory.
HP 3000 3600 3800 To install memory and font DIMMs