Setting the subnet mask

Setting the subnet mask


1. Press Menu.
2. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight CONFIGURE DEVICE, and then press HP 3000 3600 3800 check Setting the subnet mask.
3. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight I/O, and then press HP 3000 3600 3800 check Setting the subnet mask.
4. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight EMBEDDED JETDIRECT, and then press HP 3000 3600 3800 check Setting the subnet mask.
5. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight TCP/IP, and then press HP 3000 3600 3800 check Setting the subnet mask.
6. Press HP 3000 3600 3800 check Setting the subnet mask to select CONFIG METHOD.
7. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight MANUAL, and then press HP 3000 3600 3800 check Setting the subnet mask.
8. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight MANUAL SETTINGS, and then press HP 3000 3600 3800 check Setting the subnet mask.
9. Press HP 3000 3600 3800 arrow down Setting the subnet mask to highlight SUBNET MASK, and then press HP 3000 3600 3800 check Setting the subnet mask.
10. Press the HP 3000 3600 3800 arrow up Setting the subnet mask or HP 3000 3600 3800 arrow down Setting the subnet mask arrow to increase or decrease the number for the first byte of the subnet mask.
11. Press HP 3000 3600 3800 check Setting the subnet mask to move to the next set of numbers. (Press HP 3000 3600 3800 arrow return Setting the subnet mask to move to the previous set of numbers.)
12. Repeat steps 10 and 11 until the correct subnet mask is entered, and then press HP 3000 3600 3800 check Setting the subnet mask to save the subnet mask.
13. Press Menu to return to the Ready state.
HP 3000 3600 3800 Setting the subnet mask